Antclabs BL Touch Sensor

Summary

​

BLTouch is a type of semiconductor hall sensor and is an electronic component for 3D printers.

BLTouch is an auto leveling sensor for 3D Printers that can precisely measure the tilt of Bed surface. It could work with any kinds of bed materials, such as glasses, woods, metals, and so on.

​

Features

​

Main functions and controls of BLTouch are the same as usual auto bed leveling sensor, consists of RC servo and micro switch. Thus, BLTouch can be applied on almost every board.

BLTouch is fulfilled with simple structure and high precision by using progressively designed solenoid and hall sensor. It aims for user convenience and enjoyable printing by adding many smart functions, such as self-test, alarm, alarm release & Touch Switch mode, Blue LED for servo signal indicating and Z-probe(Zmin) Testing.

​

Simple

BLTouch can be easily applied, since it has a small and simple structure. As BLTouch works as usual auto bed leveling sensor, Gathering information & setting up your firmware will be an easy task.

​

Smart

Self-test : The push pin operate two times in a test when the power is on.

Alarm : The AI will flash the LED indicator if a problem is detected during a self-test or operation.

Wiring defect indicator : Blue and Red LED for indicating wiring defects. 

​

High-precision

BLTouch’s Standard Deviation in repeatability is around 0.005mm, at that precise.

​

Logic Voltage Free(Open Drain Output) 

3.3V / 5V logic voltage free(default).

​

Long stroke : ≒ 6.5mm

The stroke is up to 1.6mm longer than V2.0

For the manual follow this link.

For the full specifications follow this link.