Natural S1 PVA 1.75mm 750g PolyDissolve Polymaker

70.00 € 70.0 EUR 70.00 €

70.00 €

  • Brand
  • Color
  • Weight
  • Diameter
  • Material

This combination does not exist.

Brand: Polymaker
Color: Neutral
Weight: 750g
Diameter: 1.75mm
Material: PVA

PolyDissolve S1


PolyDissolve™ is a family of dissolvable support filaments. This family offers support solution for our portfolio of filaments. It enables a greater design freedom.

PolyDissolve™ S1 is a water dissolvable support for PLA, TPU, PVB and Nylon based filaments from our portfolio. It is specifically engineered to have a perfect interface with these materials while also displaying good solubility.

It can take 6-12hours to fully dissolve depending on your setup.
You can speed up the process:
- By increasing the water temperature
- By changing the water regularly
- By adding a pump to make the water flow


Compatible Materials:
PLA Based Materials
PETG Based Materials
PVB Based Materials (Polysmooth)
TPU Based Materials 
Nylon Based Materials

Not Compatible Materials:
ABS Based Materials
PC Based Materials


Printing Settings

Printing Temperature: 215˚C - 225˚C
Bed Temperature: 25˚C - 60˚C
Printing Speed: 30mm/s - 40mm/s
Fan: ON

Direct Drive:
Retraction Distance: 1mm
Retraction Speed: 20mm/s
Indirect Drive:
Retraction Distance: 3mm
Retraction Speed: 40mm/s

Drying Settings: 80˚C for 12h
(Only if the material has absorbed moisture)

PolyDissolve S1 is very hygroscopic, please make sure to use a dry box.